error-codes
The device might report these fault codes on the screen, but it will also be outputted on the device serial output. If you encounter a fault code, please post on the forum and we'll try to help.
:::note This table is derived from the protobufs :::
| Name | Number | Description |
|---|---|---|
| TxWatchdog | 1 | A software bug was detected while trying to send LoRa. |
| SleepEnterWait | 2 | A software bug was detected on entry to sleep. |
| NoRadio | 3 | No LoRa radio hardware could be found. |
| Unspecified | 4 | Not normally used. |
| UBloxInitFailed | 5 | Failed while configuring a UBlox GPS. |
| NoAXP192 | 6 | This board was expected to have a power management chip, but it is missing or broken. |
| InvalidRadioSetting | 7 | The channel tried to set a radio setting not supported by this chipset; radio communication settings are now undefined. |
| TransmitFailed | 8 | Radio transmit hardware failure. Data was sent to the radio chip, but it did not respond with an interrupt. |
| Brownout | 9 | Main CPU voltage dropped below the minimum acceptable value. |
| SX1262Failure | 10 | Self-test of the SX1262 radio chip failed. |
| RadioSpiBug | 11 | A failure (likely software, possibly hardware) was detected while sending packets. If this occurs on your board, please post in the forum to help us collect information to fix this bug. |
| FlashCorruptionRecoverable | 12 | Corruption was detected on the flash filesystem, but it was repaired. |
| FlashCorruptionUnrecoverable | 13 | Corruption was detected on the flash filesystem, and it could not be repaired. Note: Your node will likely need reconfiguration upon the next reboot (e.g., loss of region code). |